檢視 Maixduino 的原始碼

== Toolchain ==
<pre>
git clone https://github.com/kendryte/kendryte-gnu-toolchain
cd kendryte-gnu-toolchain
git submodule update --init --recursive
</pre>
=== Prerequisites ===
<pre>
sudo apt-get install autoconf automake autotools-dev curl libmpc-dev libmpfr-dev libgmp-dev gawk build-essential bison flex texinfo gperf libtool patchutils bc zlib1g-dev libexpat-dev
</pre>
=== Build ===
<pre>
./configure --prefix=/opt/kendryte-toolchain --with-cmodel=medany --with-arch=rv64imafc --with-abi=lp64f
make -j8
</pre>

== FW ==
<pre>
git clone https://github.com/sipeed/MaixPy.git
git submodule update --recursive --init
</pre>
=== Install dependencies ===
<pre>
sudo apt update
sudo apt install python3 python3-pip build-essential cmake
sudo pip3 install -r requirements.txt
</pre>
=== Configure project ===
<pre>
cd MaixPy
cd projects/maixpy_k210
python3 project.py --toolchain /opt/kendryte-toolchain/bin --toolchain-prefix riscv64-unknown-elf- config 
</pre>
=== Customize FW ===
<pre>
python3 project.py menuconfig
</pre>
=== Build ===
<pre>
python3 project.py build
</pre>

=== Flash to the board ===
<pre>
python3 project.py -B maixduino -p /dev/ttyUSB0 -b 1500000 -S flash
</pre>

== Example ==
<pre>
import sensor
import image
import lcd
 
lcd.init()
sensor.reset()
sensor.set_pixformat(sensor.RGB565)
sensor.set_framesize(sensor.QVGA)
sensor.run(1)
while True:
    img=sensor.snapshot()
    lcd.display(img)
</pre>