"Maixduino" 修訂間的差異
(→Toolchain) |
(→Toolchain) |
||
| 行 8： | 行 8： | ||
<pre> | <pre> | ||
sudo apt-get install autoconf automake autotools-dev curl libmpc-dev libmpfr-dev libgmp-dev gawk build-essential bison flex texinfo gperf libtool patchutils bc zlib1g-dev libexpat-dev | sudo apt-get install autoconf automake autotools-dev curl libmpc-dev libmpfr-dev libgmp-dev gawk build-essential bison flex texinfo gperf libtool patchutils bc zlib1g-dev libexpat-dev | ||
| + | </pre> | ||
| + | === Build === | ||
| + | <pre> | ||
| + | ./configure --prefix=/opt/kendryte-toolchain --with-cmodel=medany --with-arch=rv64imafc --with-abi=lp64f | ||
| + | make -j8 | ||
</pre> | </pre> | ||
於 2019年12月11日 (三) 15:08 的修訂
目錄
Toolchain
git clone https://github.com/kendryte/kendryte-gnu-toolchain cd kendryte-gnu-toolchain git submodule update --init --recursive
Prerequisites
sudo apt-get install autoconf automake autotools-dev curl libmpc-dev libmpfr-dev libgmp-dev gawk build-essential bison flex texinfo gperf libtool patchutils bc zlib1g-dev libexpat-dev
Build
./configure --prefix=/opt/kendryte-toolchain --with-cmodel=medany --with-arch=rv64imafc --with-abi=lp64f make -j8
FW
git clone https://github.com/sipeed/MaixPy.git git submodule update --recursive --init
Install dependencies
sudo apt update sudo apt install python3 python3-pip build-essential cmake sudo pip3 install -r requirements.txt
Configure project
cd MaixPy cd projects/maixpy_k210 python3 project.py --toolchain /opt/kendryte-toolchain/bin --toolchain-prefix riscv64-unknown-elf- config
Customize FW
python3 project.py menuconfig
Build
python3 project.py build
Flash to the board
python3 project.py -B maixduino -p /dev/ttyUSB0 -b 1500000 -S flash
